How to solve the problem of watch stop-and-go?

In many cases, we will find that with the watch stop and go, and then thought it was bad, in fact, not all watches stop-and-go situation is caused by failure, there are many other non-fault causes will lead to Watch stop-and-go phenomenon. Here you will tell the title of the problem of stopwatch and the reasons for the solution. After the fall of severe vibration lead to watch stop and go Environmental impact caused by the uk replica watches stop and go For a long time do not deserve to wear, lubricating oil lead to watch stop and go Mechanical watch some errors are normal, not just watch the stop-and-go without tension Very often, we will find that with the replica watches uk stop and go, and then thought it was bad, in fact, not all watches stop-and-go situations are caused by failure. Example: a Mr. spent more than 5000 pieces bought a block IHI mechanical watches, with more than 10 days to look at the needle when walking around the abnormal situation, the watches sent to a third party testing center, check the results , The watches is genuine, but also did not detect mechanical failure, but the watch stop and go of the situation still exists, then the tens of thousands of dollars Mr. watch stop and go in the end is how the matter. After the fall of severe vibration lead to watch stop and go General shockproof watch is generally able to withstand free fall from one meter high to hardwood impact. Although the shock-proof components of the watch can play a buffer role, but because the axle journal is very thin (diameter of about 0.1 mm below), if subjected to more severe vibration, or easily broken. And hard material after a strong bump, but also may cause damage to other parts. So you reflect the situation of the watch, or the need for physical testing, in order to confirm the reason. Environmental impact caused by the watch stop and go Mechanical watch travel time accuracy, in fact, will be subject to changes in the external environment, in particular, winding full-string or half-string, external force caused by swing, vibration, by the impact of magnetic and other conditions, and temperature and temperature effects are quite large , The whole mechanical watch single-ended chain and two-way chain, most of them are two-way chain, and should not be the problem, no matter how turn turn Tuo are on the chain, you do not have to worry about. Stop-and-go for two reasons, one is not a string, even if the self-winding watch, but also requires you to swing arm (at least 8 hours), you sleep at night when it is not in the chain, but ah , Chord is not enough natural will stop, you automatically swing arm on the chain, will go up. For a long time do not deserve to wear, lubricating oil lead to watch stop and go You do not wear lead to a long time froze, and asked the maintenance master to give you the oil on the mechanical watches on the OK, mechanical watches 5 years or so have to do a big maintenance. I suspect that your watches should be the second problem, life has been inadvertently bump, called the master to see you. Under normal circumstances, a little error, as long as the watch is not a stop-and-go is generally not a problem Mechanical watch some errors are normal, not just swiss replica watches the stop-and-go without tension Under normal conditions of wear wrist watch revealed today, a few seconds faster than the next day but a few seconds slower than the situation, there may be a movement of the lubricating oil changes in demand for oil, or watch the magnetic. He also said that both the astronomical watch or tourbillon watches are mechanical watches error, and their advantage over the usual watches is that in normal wear conditions, good stability, the basic can do the daily error difference Less than 1 second, on the blind pursuit of the watch does not appear to stop and go and do not care to watch the stability of many watches fans of the errors, not when to encourage everyone.